Replacing Components - Wash X/Z Subassembly
DSX™ System Service Manual 13-31
13.5.7 The Wash Z Microswitch
The Z Microswitch is a mounted on the Z-drive assembly in the upper left corner
(Figure 13-21).
To Replace the Switch:
1 Disconnect the two M2 x 12 mm Pozi Pan screws.
2 Remove the solder the wires from the switch and re-solder to the new switch.
Note: When you reconnect the wires, use good soldering technique and
make certain that the junction is protected via shrink-wrap.
3 Secure the switch using the two screws removed in Step 1.
Note: Push the switch upwards when tightening the screws.
To Next Page
Loading...
