Sample ID Module
DSX™ System Service Manual 15-15
15.5.3 Replacing the Module
The module is removed from the DSX by rotating the two screws that attach the unit to the
system (in the same manner as other modules). The module is considered as a replaceable
item and a new module is installed in the same manner as other modules.
After the scan module has been installed, test the module as described in the section entitled
Testing the Scan Module on page 15-16.
CAUTION: A CRDH CLASS II LASER IS USED TO READ THE
LABEL. WHILE THIS LASER DOES NOT POSE ANY DANGER
FROM MOMENTARY EXPOSURE TO THE EYE, IT IS SUGGESTED
THAT YOU DO NOT LOOK DIRECTLY AT THE LASER BEAM
UNLESS YOU ARE WEARING PROTECTIVE GLASSES.
To Next Page
Loading...
