Replacing the Fans
17-2 DSX™ System Service Manual
To Remove an Exhaust Fan:
1 Remove the back cover as described in the section entitled Removing the Rear
Cover on page 16-2.
2 Remove the fan cables (which are connected to J25 and J26 on the back plane
board).
3 Unscrew the four M3 hex nuts and four M8 shake proof washers on the fan to be
removed.
Note: When reinstalling the fan, it should be installed so that the air is
forced out of the interior of the system and the wires are toward the rear.
To Next Page
Loading...
