Jigs
DSX™ System Service Manual 18-3
drive assemblies, 12-2
fill step, 12-7
fluidics, 12-1
move to strips step, 12-8
operations, 12-4
overview, 12-1
purge step, 12-5
soak step, 12-6
spare parts, 13-37
sweep step, 12-8
terminate step, 12-9
troubleshooting, 13-1
washer module - removing and replacing
bearings, 13-35
dispense bottle assembly, 13-7
external components, 13-17
motor assembly, 13-36
motor pulley, 13-36
moving base assembly, 13-34
pinch valve, 13-18
plate carrier and wash head, 13-14
printed circuit board, 13-20
vacuum switch, 13-15
wash X/Z subassembly, 13-23
X/Z subassembly, 13-21
X-axis motor, 13-1
X-drive microswitch, 13-27
X-drive motor, 13-24
X-drive timing belt, 13-26
Y subassembly, 13-22
Y-drive belt, 13-32
Y-sensor assemblies, 13-35
Z-drive belt, 13-30
Z-drive motor, 13-28
Z-micro-switch, 13-31
washer test, 5-6
waste bottle
float replacement, 13-11
waste delivery system, 12-1
workspace calibration, 3-6
X transition PCB
removing and replacing, 7-51
X, Y, or Z drive assembly
jigs, 7-57
X, Y, or Z drive assembly
spare parts, 7-57
X, Y, or Z Pulleys
adjusting, 7-50
X-drive belt
checking tension, 7-56
Y-drive encoder
removing and replacing, 7-33
To Next Page
Loading...
