Post-Service Checkout Protocol
DSX™ System Service Manual 3-17
5 In the Operations to do on each strip section, select the Dispense option and
then select Aspirate. In the Purge and clean options section, select Purge the
washer first with, and enter a value of 1000ul. In the Cycle Options section,
enter the Plate Type and Cycle Mode, and select Do final aspirate cycle.
Insert a carrier with the appropriate plate and select OK.
6 The unit will perform the operation.
Note: This is a basic example of a simple wash; it can be tailored to
operate differently depending on the desired outcome.
To Next Page
Loading...
