FOR-A HVS-390HS - Selecting a VTR or VDCP Channel; Selecting the VDCP Type

198
25-2. Selecting a VTR or VDCP Channel
(1) Open the [SETUP - EXT I/F - VTR/VDCP] menu.
SETUP :>EDITOR >TSL/TLY >VTR/VDCP >ROUTER
EXT I/F :>AUD XPT
(2) Select a VTR (VTR1 to VTR4) or VDCP (VDCP1 to VDCP4) channel under SELECT.
EXT I/F :SELECT : STOP:00:00:00:00 : 1/4
VTR/VDCP:=VTR1 : DRCT REC=ON :
EXT I/F :SELECT : STOP:00:00:00:00 : 1/7
VTR/VDCP:=VDCP1 : DRCT REC=ON :
(3) When the connection to the device is established, the device status and the current time
code value will be displayed
25-3. Selecting the VDCP Type
Select a type when connecting to a VDCP device.
(1) Open the [SETUP - EXT I/F - VTR/VDCP] menu and go to PAGE 6.
EXT I/F : MODEL : : 6/7
VTR/VDCP: =Mira : :
(2) Turn F1 to select the VDCP model type. (See the table below.)
MODEL setting Description
Mira Abekas Mira Servers
HVS-5ECD FOR-A HVS-5ECD
Unavailable menu items and commands when working with Clip N Key:
 STEP-R and STEP-F >> See 25-4.
 CLIP ID setting. CLIP ID is automatically set when creating a new clip.
>> See 25-6-5.

REC DURATION setting. Stop recording manually. >> See 25-6-5.