4
WEB CONTROL
1. System Setup
1-1. System Requirements
The HVS-390HS Series web-based control feature needs a user-prepared computer, which
must meet the following system requirements.
Operation System
(tested and evaluated)
Windows XP or 7
Android 4.1.1
iOS 6.1.3
Processor Depends on the browser used.
Web browser Google Chrome or Safari recommended (Internet Explorer is
not supported.)
RAM Depends on the browser used.
Display Resolution of 1024 × 768 pixels or higher
24-bit full-color
Network Port Ethernet, at least 1 port
100BASE-TX/1000BASE-T
Network Cable 100BASE-TX: Category 5 or higher
1000BASE-T: Enhanced Category 5 or Category 6
Max. number of connection
to an HVS-390HS unit
3
1-2. Computer Network Settings
To connect to the HVS-390HS, set the IP address of your computer as follows:
IP Address 192.168.0.1 to 192.168.0.254 (except 192.168.0.10)
Subnet Mask 255.255.255.0
1-3. Connecting to the HVS-390HS
1. Launch your web browser. (Chrome or Safari recommended)
2. Enter "http://192.168.0.10" (default) in the address box and connect to the HVS-390HS.
If you have changed the HVS-390HS IP address, enter the changed address.
3. The HOME screen as shown on the next page will appear.
Verify that the connection indicator in the upper right corner is lit green.
Note that web browsers cannot automatically reconnect to HVS-390HS units after the
units have rebooted (the connection indicator may be unlit). In such case, reconnect to
the unit or refresh the HVS-390HS control page on the web browser to re-establish the
connection.