25
HVS-30OU
8. Event Memory
The HVS-30OU units can store and retrieve event data in the similar way as the HVS-390HS
standard operation units.
8-1. Event Operation
This section shows how to store and load events. See the main manual pages for details about
event menu operation.
To Store an Event (basic):
(1) Press the EVENT memory button right next to the Menu Display.
(2) Press STORE on the Keypad.
(3) Press a number button (0-9) on the Keypad to store the event.
To Recall an Event (basic):
(1) Press the EVENT memory button right next to the Menu Display.
(2) Press the number button where the needed data is to be stored.
(3) Press the RECALL button. The selected event will then be applied to the panel.
Button LED indication Description
EVENT Lit Indicates that the event operation is enabled.
0-9
Lit Indicates that the button has event data.
Flashing Indicates that event data is going to overwritten.
Unlit Indicates that the button doesn't have event data.
RECALL Lit
Pressing the button recalls the data from the event
memory.
STORE Lit
Pressing the button stores the event data in the event
memory.
MENU/DIRECT PATT/EVENT/KEY PAD
7/SET UP
4/WIPE
1
8/STILL
5/P in P
2/KEYER
9/FILE
6/MATT
3/DSK
MENU
DIRECT PATT
±/EVENT
CLR/TRANS RATE 0 /RECALL
. (DOT)
ENT/STORE
EVENT button
0 to 9
STORE button
RECALL button