39
4-3. Copying / Swapping Settings
Keyers can be set up easier with this feature by copying settings from one to another, swapping
settings between KEY1 and KEY2, or copying settings from KEY1 to KEY4.
4-3-1. Operation Example: Copying Settings from KEY2 to KEY4
(1) Press COPY/SWAP in the CONTROL block above the Keypad. The button's light turns on
and the COPY SWAP menu is displayed (see "DIRECT ON/OFF" and "XPT ON/OFF.")
and available buttons on the keypad turns on green.
(2) Press COPY. (Press SWAP if you want to swap settings.)
(3) Press KEY2 to copy the settings. The button will light up orange.
(4) Press KEY4 to set the destination bus. The button will light up orange.
(5) Press ENTER to paste the settings to KEY4. To cancel the process, press COPY/SWAP.
(If DIRECT mode is ON, copy and paste are performed without pressing ENTER. See
"DIRECT ON/OFF" below.)
Copying and swapping settings are available among KEY1 to 4. For KEY3 and KEY4,
however, keyer's additional features such as Wipe and Chromakey are not copied or
swapped.
DIRECT ON/OFF
If DIRECT is set to ON, copy and paste are performed without pressing ENTER.
COPY/ :DIRECT : :XPT : :1/1
SWAP : =OFF : :=--- : :
XPT ON/OFF
If XPT is set to ON, the signal selections such as key source and insert signal settings are
also copied to or swapped between.
SELECT / KEYPAD
5
2
RECALL
PASTE
4
1
6
3
DEC
SEQUENCEEVENTWIPE MACRO
CON TROL
MEM ORY
MENU USER BUTTON COPY/ SWAP SEQ EDI T
987
ATTACH
INC
MENU
COPY
STILL MAT T
SWAP NEW
FILE
INS
KEY4KEY3KEY2KEY1
DETTACH
ADDDELCUTPLAY
+/-
CLE AR
WIPE
STOP
0
COPY
STO RE
ENTER
OVWR