26
HVS-30OU
9. User Buttons
User buttons can be assigned to specific menu pages and used as shortcuts or specific
functions buttons.
9-1. USER Button Operation
The following 6 user buttons (OU1-OU6) are available in the switcher.
Pressing a user button lets you open the desired menu page or perform the desired function. In
the factory default setting, The GPI IN On/Off and Editor On/Off functions are assigned to OU1
and OU2 respectively.
NOTE
As the factory default setting, no menu page or functions are assigned to user buttons
on the Keypad. Assign a desired menu page or a function following the procedure
below.
9-2. USER Button Setting
USER Button Default Assignments
Button Default Setting
USER BUTTON 1 (OU-1) GPI IN ENABLE
USER BUTTON 2 (OU-2) EDITOR ENABLE
USER BUTTON 3-6 NOne
(1) Press the USER BUTTON above the Keypad to display the [USER BTN] menu.
(2) Turn F1 to select a USER button for use. The selected USER button blinks.
(3) Select MENU or the function type under TYPE.
USER :SELECT : TYPE : FUNC(F3) : 1/1
BUTTON : =OU-1 : =NONE : =(NOT ASSIGN)
If Menu Shortcut is Set:
Turn F2 to select TYPE to MENU and press F2. Then turn F3 to select a menu page and press
F3. Once the menu shortcut is assigned to a User button, pressing the button opens the
assigned menu page.
USB MEMORY
(PUSH to DEF)
43
65
SIZE
F4
F3F2
F1
PAGE
USER B UTTON
12
POSITION
MENU/DIRECT PATT/EVENT/KEY PAD
ALARMUSER BUTTON
HV S-300HS
DIGITAL VIDE O SW ITCHER
7/SET UP
4/WIPE
1
8/STILL
5/P in P
2/ KEYER
9/FILE
6/MATT
3/DSK
BLA CK
TRANS
MENU
DIRECT PATT
±/EV ENT
CLR/TRANS RATE 0 / RECALL
. (DOT)
ENT/ ST ORE
OU1 and
OU2
OU3 to
OU6
To Next Page
Loading...
