FOR-A HVS-390HS User Manual

78
8-9-1. Setting the KEY ON AIR Button Function (USER Transition)
The KEY ON AIR function is set to CUT as factory default.
To set KEY1 ON AIR on M/E1 to SLIDE TOP, proceed as follows:
(1) Press the TRANSITION RATE button above the KEY1 ON AIR button to display the
[TRANS] menu. Go to PAGE 3.
Users can also display the [TRANS] menu
by quickly pressing the following buttons twice:
BKGD, KEY1 to KEY4 and MIX in the NEXT TRANSITION block.
(2) Turn F1 to select M/E1 KEY1 under SELECT.
(3) Turn F2 to select SLIDE TOP.
TRANS :SELECT : USER TRANS :ADV CTL: 3/4
USER/ADV: =M1KY1: =SLIDE TOP : =AUTO :
 KEY ON-AIR Button Function Settings
Item Setting Description
USER
TRANS
CUT
Cuts images in or out.
SCALER
Scales up to insert images or scales down to
remove images.
SLIDE RIGHT/LEFT
Slides in to insert images or slides out to remove
images.
SLIDE TOP/BOTTOM
WIPE RIGHT/LEFT
Wipes images in or out.
WIPE TOP/BOTTOM
OFF
Disables the button function.
REV NOR/REV
PATTERN
BKGD
DIRECTION
KEY1 KEY2
KEY3 KEY4
NEXT TRANSITION
FASER LIMIT
MIX
WIPE
TRANSITION TYPE
AUTO CUT
ON AIR
DVE
DVE
KEY 4
KEY 3
KEY 2
DVE
KEY 1
DVE
Buttons turn on while On-Air.
Buttons turn off while Off-Air.

FOR-A HVS-390HS Specifications

General

Brand	FOR-A
Model	HVS-390HS
Category	Switch
Language	English