FOR-A HVS-390HS User Manual

227
32. Upgrading an Operational Version
Consult your FOR-A supplier in order to upgrade your switcher.
Before upgrading, check the current version of the software and firmware in the [SETUP -
STATUS - VERSION] menu.
You will need to use the FILE special menu function to download and apply operational software
files in a USB flash memory. The files listed below contain the software upgrades for your
switcher.
 Upgrade Files for HVS-390HS
File extension Description
MCB For software updates (main data)
MDB For software updates (sub data)
MDH For software updates
MFB For FPGA firmware updates
MVF For MV firmware updates
 Upgrade Files for HVS-391OU
OCD For HVS-391OU software updates
OUF
Bitmap images for the control panel bus buttons.
(See section 32-4.)
OFB For HVS-391OU FPGA firmware updates
 Upgrade Files for HVS-30RU
RUB For HVS-30RU software updates
32-1. Upgrade Precedure
Once the system is upgraded, the setting data will be lost and returns to the factory default
settings. Important setting data should be backed up by saving it to USB flash memory.
To upgrade your switcher, follow the procedure below:
Step Description Refer to
1 Save current setting data to USB flash memory. 19-3
2 Upgrade the software 32-2
3 Reboot the switcher. 23-1
4 Initialize the switcher. 23-2
5 Load the setting data saved at step 1. 32-3
6 Reboot the switcher. 23-1
7 Turn power off then on at the OU
IMPORTANT
Once the saved system data is
loaded, you will have to restart the switcher. (Power the
unit OFF then ON.) The ARCNET ID is applied only after the switcher is restarted.

FOR-A HVS-390HS Specifications

General

Brand	FOR-A
Model	HVS-390HS
Category	Switch
Language	English