EasyManuals Logo

FOR-A HVS-390HS User Manual

FOR-A HVS-390HS
326 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #144 background imageLoading...
Page #144 background image
144
17-1-4. Playing Back Sequences Using Advanced Settings
Playing Sequences by Changing Bus Signal Selections
Sequence data includes that on bus signal selection states and are basically recalled on the
control panel exactly the same that they were stored. For example, if Bus Button 1 was
selected in the PGM bus and Bus Button 2 in the PST bus in the sequence, these buttons
should be selected in the same way when recalling the sequence.
However, users can select 5 in the PGM and 6 in the PST when recalling the sequence.
To do this, follow the procedure below.
(1) Press SEQUENCE to display the [SEQUENCE MEMORY] menu.
(2) Press 0 to select "Sequence Memory 0."
(3) Press RECALL to recall the data that was stored in "Sequence Memory 0" to the working
memory.
(4) Press SEQ EDIT to display the [SEQ EDIT] menu.
(5) Press the page down button twice to go to PAGE 3.
(6) Turn F1 to select ALL (all buses) or M/E1 BG.
(7) Turn F2 to set XPT to OFF.
SEQ EDIT:SELECT : XPT : TRANS :INTERP : 3/3
CTRL ENA: =ALL : =OFF : =AUTO : =LINE :
(8) Press 5 in the PGM bank and press 6 in the PST bank.
(9) Press +/- (PLAY) to play back the sequence.
Playing Sequences without Specific Bus(es) or Using Manual Transitions
The sequences can be played back without KEY1 and by using manual transitions for KEY2.
To do this, follow the procedure below.
(1) Open PAGE 3 in the [SEQ EDIT] menu.
(2) Set SELECT to ME1 K1 and TRANS to OFF.
SEQ EDIT:SELECT : XPT : TRANS :INTERP : 3/3
CTRL ENA: =ME1K1: =OFF : =OFF : =LINE :
(3) Set SELECT to ME1 K2 and TRANS to MANU.
SEQ EDIT:SELECT : XPT : TRANS :INTERP : 3/3
CTRL ENA: =ME1K2: =OFF : =MANU : =LINE :
OFF The selected bus is not played back.
AUTO (default setting) The selected bus is automatically played back.
MANU (manual)
The transition for the selected bus should be performed manually by
using the fader lever or the AUTO button.
Note that even if AUTO or MANU is set for a bus at TRANS, it cannot be performed if the
Fader Link of the bus is set to ON.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the FOR-A HVS-390HS and is the answer not in the manual?

FOR-A HVS-390HS Specifications

General IconGeneral
BrandFOR-A
ModelHVS-390HS
CategorySwitch
LanguageEnglish

Related product manuals