FOR-A HVS-390HS User Manual

145
 Playing Sequences Using the Fader Lever
The playback of sequences can be played back using the fader lever. To do this, follow the
procedure below.
(1) Open PAGE 1 in the [SEQ EDIT] menu.
(2) Set LINK to ON.
SEQ EDIT: LOOP : DIR : LINK :TOTAL-D: 1/3
PLAY : =ON : =NOR : =ON : =100 :
(3) Move the fader lever from end to end to play the sequence one time with the desired play
time.
Note that when the Fader Link for a bus is set to ON
, fader operations cannot be
performed if AUTO or MANU is set for the bus at TRANS. In such case,
the looping
playback cannot be performed, even if LOOP is set to ON,
 Playing Sequences with the Fader Lever or the PLAY Button Using the Break
Function
The Break function can automatically pause sequence playback at a desired step. The
setting example below shows how to set the Break function at Step 2 and how to play back
the sequence with the AUTO button using the Break function.
(1) Open PAGE 2 in the [SEQ EDIT] menu.
(2) Select 2 at STEP.
(3) Set BREAK to ON.
(4) Set BRK CTL to EACH.
SEQ EDIT: STEP : DUR : BREAK :BRK CTL: 2/3
STEP : = 2/ 3: =30 : =ON : =EACH :
BRK CTL setting BREAK setting Description
OFF --- The Break function is disabled at all steps.
EACH
OFF The Break function is disabled at this step
ON The Break function is enabled at this step.
ALL --- The Break function is enabled at all steps.
(5) Open PAGE 1 in the [SEQ EDIT] menu and set LINK to ON.
SEQ EDIT: LOOP : DIR : LINK :TOTAL-D: 1/3
PLAY : =ON : =NORML: =ON : =60 :
(6) Press +/- (PLAY) to start the sequence playback. The sequence will stop at Step 2. Press
+/- (PLAY) again to restart the sequence. The sequence will be played back from Step 2
to the end. The sequence playback with break points is also performed with the fader
lever in the same way.
First playback
Second
playback

FOR-A HVS-390HS Specifications

General

Brand	FOR-A
Model	HVS-390HS
Category	Switch
Language	English