KIP 700m - 016 Cut Length 1 (length information provided); 017 Cut Length 2 (length information not provided)

K117sm8e6
8-50
016 Cut Length 1 (length information provided)
It is possible to make the print length longer or shorter.
This setting is applied when the print command (plot & copy) is provided with the length
information. (this is command used on all standard pages printed from the IPS)
If you increase the setting value by “+1”, the print length becomes 1mm longer.
Setting Range Step of increment
0 to 100 1mm
Setting value is increased. Setting value is decreased
.
Cut length
017 Cut Length 2 (length information not provided)
It is possible to make the print length longer or shorter.
This setting is applied when the print command (plot & copy) is not provided with the length
information. (This is may only be used on LONG prints over 6 meters on the IPS)
If you increase the setting value by “+1”, the print length becomes 1mm longer.
Setting Range Step of increment
0 to 100 1mm
Setting value is increased. Setting value is decreased
.
Cut length