K117sm8eC
8-164
8. 13. 6 Registering S/N to Scanner Main Board
The scanner unit’s Main Board stores its serial number (same with the machine S/N). As a service
part Main Board has no S/N information, you will have to write the printer’s serial number (with 8
digits) to the Main Board.
1. Open the Properties panel of Scanner Utility’s shortcut.
2. Add the following text to the end of the target path.
“(one byte space)/Service”
3. Press [OK].
/Service
NOTE
If you use a service part with S/N unwritten or with wrong information (different S/N from one
written before), such Main Board would be detected as an incorrect hardware configuration.
This would invalid some license key codes.
You cannot enter another S/N any more once registered, including correction of a
wrong entry. (loss of warranty)
NOTE
Scanner Firmware 1.21 or higher, and Scanner Utility 1.51 or higher are required.
To Next Page
Loading...
