KIP 700m - 782 Side Registration (Paper Tray); 783 Forced Initial Cut Before Print (Cut Length)

K117sm8e7
8-84
782 Side Registration (Paper Tray)
It is possible to specify where to start printing the image at the side edge of a sheet from the Paper
Tray.
If you increase the setting value by “+1 “, image is shifted 0.1mm to the right.
Setting Range Step of increment
0 to 100 0.1mm
Setting value is increased.
Side Registration
Setting value is decreased.
783 Forced Initial Cut Before Print (Cut Length)
Under a certain usage environment, the first print of a job sometimes would have a wrinkle or an
image void if the prints are made with a roll media left in the deck for a long period.
“Forced Initial Cut Before Print” is a function to make an automatic initial cut in a certain amount at
the leading edge before processing a job to obtain image quality and feed balance in such
conditions.
No.783 specifies how long millimeters to be cut (and ejected) by “Forced Initial Cut Before Print”.
Note that you can configure which media type “Forced Initial Cut Before Print” works on in the UI
screen.
Setting Range Step of increment
279 to 600 1mm
Reference
No.783 Specifies “how long” to be cut. “Forced Initial Cut Before Print” can be validated in
the UI screen by media type.