KIP 700m - 063, 064 Cut Length 5 & 6 (Length Compensation for Tracing Paper; Film)

K117sm8e6
8-62
063, 064 Cut Length 5 & 6
(Length Compensation for Tracing Paper / Film)
It is possible to compensate the print length for the tracing paper and film.
If you increase the setting value by “+1”, the length of the print becomes longer.
Item No. Setting Item Setting range Step of increment
063 Cut Length 5 (Tracing Paper) 0 to 200 depends on paper length
064 Cut Length 6 (Film) 0 to 200 depends on paper length
An amount of the length to be added / removed against “1” increment of the setting value will vary
depending on the length of the media length to be printed.
“1” increment will correspond to the length listed below to be compensated.
paper length
length to be added /
removed (Approx.)
A0 (1189mm) 0.16mm
A1 (841mm) 0.11mm
A2 (594mm) 0.08mm
A3 (420mm) 0.05mm
A4 (297mm) 0.04mm
Expected length Actual length
Increasing the value
Expected length Actual length
0
100
50
A B C
0
100
50
A B C
0
100
50
A B C
0
100
50
A B C