KIP 700m - 874 to 885 Transfer Corona OFF Timing (Bypass); 886 to 897 Separation Corona OFF Timing (Bypass)

K117sm8e7
8-91
874 to 885 Transfer Corona OFF Timing (Bypass)
It is possible to adjust the timing that the Transfer Corona stops discharging during the print cycle.
This can be configured by every media type / width.
If you increase the setting value by “+1”, the timing to stop discharging is 1mm delayed.
Setting Range Step of increment
0 to 100 1mm
Plain
Paper
Tracing
Paper
Film
A3, 11”, 12” No.874 No.875 No.876
A2, 15”, 17”, 18” No.877 No.878 No.879
A1, 22”, 24” No.880 No.881 No.882
A0, B1, 30”, 34”, 36” No.883 No.884 No.885
886 to 897 Separation Corona OFF Timing (Bypass)
It is possible to adjust the timing that the Separation Corona stops discharging during the print
cycle. This can be configured by every media type / width.
If you increase the setting value by “+1”, the timing to stop discharging is 1mm delayed.
Setting Range Step of increment
0 to 100 1mm
Plain
Paper
Tracing
Paper
Film
A3, 11”, 12” No.886 No.887 No.888
A2, 15”, 17”, 18” No.889 No.890 No.891
A1, 22”, 24” No.892 No.893 No.894
A0, B1, 30”, 34”, 36” No.895 No.896 No.897
NOTE
You may lose some trailing image as the following example if you decrease the setting value
too much, because the Transfer Corona stops discharging too early.
Normal Setting value is increased too much.
Transfer Corona stops
discharging at this point.