K117sm8e7
8-64
310 to 315 Main Motor Speed
It is possible to adjust the speed of Main Motor for each type of paper separately.
If you increase the setting value by “+1”, the motor speed becomes 0.02mm/second faster.
Item
No.
Setting Item Setting
range
Step of
increment
310 Main Motor Speed (Plain paper) 0 to 80 0.02mm/s
311 Main Motor Speed (Tracing paper) 0 to 80 0.02mm/s
312 Main Motor Speed (Film) 0 to 80 0.02mm/s
313 Main Motor Speed (Special plain paper) 0 to 80 0.02mm/s
314 Main Motor Speed (Special tracing paper) 0 to 80 0.02mm/s
315 Main Motor Speed (Special film) 0 to 80 0.02mm/s
508 to 510 Transfer Voltage applied at 100mm from trailing edge
It is possible to adjust the analog voltage to Transfer Corona on 100mm end of a print.
Item
No.
Setting Item Setting
range
508 Transfer Voltage applied at 100mm from trailing edge (Plain) 0 to 9FE
509 Transfer Voltage applied at 100mm from trailing edge (Tracing) 0 to 9FE
510 Transfer Voltage applied at 100mm from trailing edge (Film) 0 to 9FE
511 to 513 Transfer Voltage applied at 70mm from trailing edge
It is possible to adjust the analog voltage to Transfer Corona on 70mm end of a print.
Item
No.
Setting Item Setting
range
511 Transfer Voltage applied at 70mm from trailing edge (Plain) 0 to 9FE
512 Transfer Voltage applied at 70mm from trailing edge (Tracing) 0 to 9FE
513 Transfer Voltage applied at 70mm from trailing edge (Film) 0 to 9FE
CAUTION
The Main Motor Speed is the basis for many other print settings.
So you have to re-adjust all of these print settings if you change the Main Motor Speed.
To Next Page
Loading...
