KIP 700m - 660 to 665 Ready - Fuser Temperature

K117sm8e7
8-72
660 to 665 Ready - Fuser Temperature
It is possible to specify “Ready” temperature.
You can specify the temperature for each type of media separately.
This setting will be applied only when Fuser Temperature is below 50
o
C at turning on the machine.
The Fuser Temperature becomes 1 degree higher if you increase the setting value by “+1”.
Item No. Setting Item Setting
range
Step of
increment
660 Ready - Fuser Temperature (Plain) 120 to 180 1
o
C
661 Ready - Fuser Temperature (Tracing) 120 to 180 1
o
C
662 Ready - Fuser Temperature (Film) 120 to 180 1
o
C
663 Ready - Fuser Temperature (Special / Plain) 120 to 180 1
o
C
664 Ready - Fuser Temperature (Special / Tracing) 120 to 180 1
o
C
665 Ready - Fuser Temperature (Special / Film) 120 to 180 1
o
C
After reaching “Ready”, fuser temperature will rise 10
o
C higher than “Ready” (Overshoot) in 10
minutes. Then it will be maintained within “Standby” temperature.
Fuser Temperature Overshoot
in 10 minutes after Ready
(
o
C) Standby
Overshoot
Setting value of
“Ready - Temperature”
50
o
C
0 (Time)
Turn on Ready