KIP 700m - 617 to 620 Additional Cut Length for Non-standard Size Prints; 621 Toner Supply Roller Bias; 622 Regulation Bias; 624 Density Sensor Analog Voltage

K117sm8e7
8-67
617 to 620 Additional Cut Length for Non-standard Size Prints
It is possible to avoid the lack of trailing image on the non-standard size print, by providing
additional paper length by service modes 617 to 620 (Additional Cut Length for non-standard size
print).
Additional Cut Length specified by service mode 617 to 620 is not always provided.
Whether or not it is provided is judged by service mode 613 to 616 (Judgment value for “Additional
Cut Length for non-standard size print”.)
Item
No.
Setting Item Setting
range
Step of
increment
617 Additional Cut Length for Non-standard Size Prints (36”/ 34”/ 30”/ A0 / B1) 0 to 35 1mm
618 Additional Cut Length for Non-standard Size Prints (24”/ 22”/ A2) 0 to 35 1mm
619 Additional Cut Length for Non-standard Size Prints (18”/ 17”/ 15”/ A2) 0 to 35 1mm
620 Additional Cut Length for Non-standard Size Prints (12”/ 11”/ A3) 0 to 35 1mm
621 Toner Supply Roller Bias
It is possible to make bias adjustment for Toner Supply Roller.
Setting Range
10 to 800
622 Regulation Bias
It is possible to make the print density darker or lighter by adjusting Regulation Bias (Center).
The print density becomes darker if you increase the setting value.
Setting Range
10 to 800
624 Density Sensor Analog Voltage
It is possible to change the default analog output of Density Sensor.
“Density Sensor Standard Output” (No.623) and “Density Sensor Analog Voltage” (No.624) are
used for Density Measure.
Setting Range
0 to 60
NOTE
This setting does not function. Change of this setting has no effect on the machine operation.
NOTE
Please adjust Regulation Bias while checking the actual voltage with the multi-meter.
NOTE
This setting has been factory-adjusted. Keep the value unchanged.