KIP 700m - Chapter 8 Service Mode; Utility

K117sm8e1
Chapter 8
Service Mode / Utility
Page
8. 1 General Information of Service Mode 8- 1
8. 2 KIP Service Software Overview 8- 2
8. 2. 1 Launching KIP Service Software 8- 4
8. 2. 2 Closing KIP Service Software 8- 7
8. 2. 3 Log In screen 8- 8
8. 2. 4 Service Mode Home 8- 9
8. 2. 5 Serial Port Setting 8-10
8. 3 Signal Status Mode 8-11
8. 3. 1 Monitoring Signal Status 8-12
8. 3. 2 Input / Output Signal List 8-15
8. 4 Information Mode 8-17
8. 4. 1 Monitoring Analog Data 8-21
8. 4. 2 List of Analog Data Monitor 8-23
8. 4. 3 Browsing Jam History 8-24
8. 4. 4 Browsing Error History 8-25
8. 5 Operation Check Mode 8-26
8. 5. 1 Checking Device Operation 8-27
8. 5. 2 Device List 8-29
8. 6 Adjustment Mode 8-30
8. 6. 1 Changing Setting Value 8-32
8. 6. 2 Setting Item List 8-37
8. 6. 3 Setting Item Explanation 8-41
000, 001 Leading Registration 8-41
002, 003 Trailing Margin 8-41
004 Side Margin (Left & Right) 8-42
005, 006 Side Registration 8-43
008 to 010 LED Strobe Time for Main Pixel 8-44
011 to 013 LED Strobe Time for IST (Supplemental Pixel) 8-46
014, 015 Vertical Alignment of Pixels between Image Blocks 8-48
016 Cut Length 1 (length information provided) 8-50
017 Cut Length 2 (length information not provided) 8-50
018 Cut Length 3 (Compensation of a long print) 8-51
019 Leading Margin 8-53
020 to 027 Developer Bias 8-54
028 Developer Bias compensation - 1st Drum revolution 8-54
029 to 034 Transfer Voltage 8-55
035 Separation Corona ON Timing 8-55
037 Transfer Corona ON Timing 8-56
045 Fuser Temperature to start idling 8-57
046 Warm Sleep – Fuser Temperature 8-57
048, 049 Fuser Temperature Control Range 8-58
050 Reaction Time of Toner Supply Motor 8-59
051 Toner Supply Motor ON Time 8-59