K117sm8e1
052 Dot Enhancement Level (Dither) 8-60
055 Metric or Inch 8-60
056 Language 8-61
059 Counter Unit 8-61
060 Maximum Length 8-61
063, 064 Cut Length 5 & 6 (Compensation for Tracing Paper / Film) 8-62
065 Drum Reverse Rotation Period 8-63
310 to 315 Main Motor Speed 8-64
322 to 327 Separation Corona OFF Timing 8-64
511 to 513 Transfer Voltage applied at 70mm from trailing edge 8-64
613 to 616 Judgment Value for Additional Cut Length
for Non-standard Size Prints 8-65
617 to 620 Additional Cut Length for Non-standard Size Prints 8-67
621 Toner Supply Roller Bias 8-67
622 Regulation Bias 8-67
624 Density Sensor Analog Voltage 8-67
625 to 630 Print - Fuser Temperature (12”/11”/A3) 8-68
631 to 636 Print - Fuser Temperature (18”/17”/15”/A2) 8-68
637 to 642 Print - Fuser Temperature (24”/22”/A1) 8-69
643 to 648 Print - Fuser Temperature (36”/34”/30”/A0/B1) 8-69
649 Density Sensor Output Monitor 8-69
652 Density Compensation ON/OFF 8-70
653 Target Density 8-71
654 Regulation Bias Maximum 8-71
655 Density Measure Interval 8-71
660 to 665 Ready - Fuser Temperature 8-72
738 Standby - Fuser Temperature 8-73
749 Tracing Mode 8-73
751 Disable HV Error Detection Mode 8-74
753 Counter Setting 8-74
754 Total Increment of Developer Bias Adjustment 8-74
755 Developer Bias Increment for Adjustment Level 1 and After 8-75
756, 757 Developer Bias Limit 8-75
758 Total Increment of Regulation Bias Adjustment 8-75
759 Regulation Bias Increment for Adjustment Level 2 and After 8-76
760, 761 Regulation Bias Limit 8-76
762 to 767 Developer Reference Bias 8-76
768 Motor Setting 8-77
769 Wait Time of Media Feed Start 8-77
770, 771 Additional Toner Supply Time 8-77
772, 773 Horizontal Alignment of LED Head Blocks 8-78
774 to 777 Dot Light Level on Border Pixel 8-81
778, 779 Strobe Time Adjustment on Border Pixel 8-82
781 Trailing Margin for Paper Tray 8-83
782 Side Registration for Paper Tray 8-84
783 Forced Initial Cut Before Print (Cut Length) 8-84
784, 785 Limit Temperature of LED Stitch Compensation 8-85
787 Transfer Corona ON Timing Compensation (Paper Tray) 8-85
788 Transfer Corona OFF Timing Compensation (Paper Tray) 8-86
789 to 800 Transfer Corona OFF Timing (Roll) 8-87
801 to 812 Separation Corona OFF Timing (Roll) 8-88
813 Encoder Type 8-88
814 to 867 Cut Length Compensation (Special Size) 8-89
868 to 870 Leading Registration (Paper Tray) 8-90
871 to 873 Paper Tray Motor Speed 8-90
874 to 885 Transfer Corona OFF Timing (Bypass) 8-91
886 to 897 Separation Corona OFF Timing (Bypass) 8-91
8. 6. 4 Creating Backup 8-89
8. 6. 5 Restoring Configuration from Backup 8-91
To Next Page
Loading...
