KIP 700m - Page 339

K117sm8e1
8. 7 Running Mode (Factory Use Only) 8-93
8. 8 Jam/Error Mask Mode 8-93
8. 8. 1 Mask List 8-96
8. 8. 2 Masking Jam 8-97
8. 8. 3 Masking Error 8-100
8. 9 Test Print Mode 8-103
8. 9. 1 Making Test Print 8-105
8. 9. 2 Built-in Test Pattern 8-107
8. 10 Factory Adjustment Mode (Factory Use Only) 8-107
8. 11 Special Operation Mode 8-108
8.11.1 Special Operation List 8-110
8.11.2 Clearing Fuser Error, Jam/Error History 8-111
8.11.3 Reset of Bias Adjustment by Density Compensation Process 8-113
8.11.4 Toner Supply Mode 8-116
8. 12 Send Firmware Mode 8-119
8.12.1 Sending Firmware to Printer 8-120
8.12.2 In Case of Transmission Failure 8-123
8. 13 KIP Scanner Utility (for Old Scanner) 8-126
8.13. 1 Installation 8-126
8.13. 1. 1 Installing USB Driver 8-126
8.13. 1. 2 Installing KIP Scanner Utility 8-129
8.13. 2 Starting KIP Scanner Utility 8-132
8.13. 3 Checking Scanner Information 8-133
8.13. 3. 1 Displaying Scanner Information 8-133
8.13. 3. 2 File Check 8-134
8.13. 4 Scanner Adjustment Procedure 8-135
8.13. 4. 1 Shading (Calibration) 8-135
8.13. 4. 2 Feed Distance (1:1) 8-143
8.13. 4. 3 Position (Stitching) 8-151
8.13. 5 Updating Scanner Firmware 8-161
8.13. 6 Registering S/N to Scanner Main Board 8-164
8.13. 7 Scanner Assembly Sleep 8-166
8. 14 K129 Diag (for New Scanner) 8-167
8.14. 1 K129 Diag Overview 8-167
8. 14. 1. 1 K129 Diag System Requirements 8-167
8. 14. 1. 2 K129 Diag Tree Diagram of Screen Hierarchy 8-168
8.14. 2 Starting K129 Diag 8-169
8.14. 3 Version 8-173
8.14. 4 Backup Data 8-174
8.14. 4. 1 Changing Backup Data 8-174
8.14. 4. 2 Saving the Current Backup Data 8-179
8.14. 4. 3 Editing Backup Data File 8-181
8.14. 4. 4 Restoring Backup Data 8-182
8.14. 4. 5 Backup Data List 8-185
0 Lead Regist 8-189
1 T Margin 8-189
3 Motor Correction 8-189
4 Offset Level 8-189
5 ED Gamma Select 8-190
6 Sleep Time 8-190
9 Doc. Entry Time 8-190
11 Doc. Entry Speed 8-190
12 Correction Time 8-191