KIP 700m - 037 Transfer Corona ON Timing

K117sm8e6
8-56
037 Transfer Corona ON Timing
It is possible to adjust the timing that the Transfer Corona starts discharging during the print cycle.
If you increase the setting value by “+1”, the timing to start discharging is 1mm delayed.
Setting Range Step of increment
0 to 100 1mm
NOTE
You may lose some leading image as the following example if you increase the setting value
too much, because the timing to start discharging is too much delayed.
Normal Setting value is increased too much.
Transfer Corona starts
discharging at this point.