K117sm8eB
8-142
12. Move the red cursor so that its vertical line matches the defective pixel and click it.
The defective pixel is selected by this operation.
If there are some more defective pixels, select them in the same way.
Match the vertical line to a defective pixel.
13. Click [Execute], and the selected “defective pixel” is compensated individually.
14. You will be asked to set Shading Sheet again.
Set Shading Sheet to the scanner and click [OK].
Check the result of Shading again.
When finished, click [Close].
15. Shading (“white balance” / “color” calibration) is completed.
To Next Page
Loading...
