KIP 700m - Page 505

K117sm8eC
8-160
16. Start Adjust Position again. Make a rescan of Stitch Adjustment Chart.
Confirm the result of the adjustment. If the gap disappears, LE positioning
is completed.
17. The entire Position adjustment is completed.
NOTE
If the rescan image still has a gap, go back to step 11 to remove it completely.
Every scan image has a blank band on the leading edge by the gap.
Be sure to remove the gap completely.
If the image on the leading edge is missing, the reading start is too late. Go back to step 4.
No gap (band area)
gap (band)
reading start here
original LE
Press Roller
reading start here
original LE