K117sm8eE
8-205
3. Click [select].
4. Specify a shading data file (*.bin) you want to import.
5. The selected file name appears in the upper field. Click [restore].
6. When “done” is displayed, sending the shading data file to the scanner is completed
Click the X button at the top right corner to close “Restore Shading Data” sub window.
7. Turn off the scanner. Wait 3 seconds and then turn it on.
Now the selected shading data file is validated.
NOTE
If you quickly turn off and on again, “The device can run faster...” balloon would pop up.
This is because the scanner firmware may be loaded to the scanner’s memory incorrectly.
Please wait 3 seconds before turning on again.
NOTE
At this time the shading data has just been sent to the Main Board, but is not validated yet.
To Next Page
Loading...
