Lexmark X95 series - Page 235

Diagnostic information 2-185
7558-xxx
Go Back
Previous
Next
3
Is the sensor (stacker bin no
media) properly connected?
Replace the sensor (stacker bin
no media). Go to “Sensor
(stacker bin upper limit) or
sensor (stacker bin no media)
removal” on page 4-403.
Replace the connection.
4
Check the sensor (stacker bin
level R) for proper operation.
1. Enter the Diagnostics Menu.
2. Touch SENSOR TESTS.
3. Touch FINISHER SENSOR
TESTS.
4. Touch Sensor (Stacker bin
level 1).
Does the display on the
operator panel change every
time the sensing area of the
above sensor is interrupted or
blocked?
Go to step 6. Go to step 5.
5
Check the sensor (stacker bin
level R) for proper connection.
Is the above component
properly connected?
Replace the sensor (stacker bin
level R). Go to “Sensor (stacker
bin level R) removal” on
page 4-402.
Replace the connection.
6
Check the sensor (stacker bin
level F) for proper operation.
1. Enter the Diagnostics Menu.
2. Touch SENSOR TESTS.
3. Touch FINISHER SENSOR
TESTS.
4. Touch Sensor (Stacker bin
level 2).
Does the display on the
operator panel change every
time the sensing area of the
above sensor is interrupted or
blocked?
Go to step 8. Go to step 7.
7
Check the sensor (stacker bin
level F) for proper connection.
Is the above component
properly connected?
Replace the sensor (stacker bin
level F). Go to “Sensor (stacker
bin level F) removal” on
page 4-401.
Replace the connection.
8
Check the sensor (stacker bin
level encoder) for proper
operation.
1. Enter the Diagnostics Menu.
2. Touch SENSOR TESTS.
3. Touch FINISHER SENSOR
TESTS.
4. Touch Sensor (Stacker bin
level encoder).
Does the display on the
operator panel change every
time the sensing area of the
above sensor is interrupted or
blocked?
Go to step 10. Go to step 9.
Step Action and questions Yes No