Lexmark X95 series - Page 546

4-68 Service Manual
7558-xxx
Go Back
Previous
Next
8. Remove the operator panel front cover. See “Operator panel front cover (MFP) removal” on page 4-8.
9. Remove the printhead retract door. See “Printhead retract door removal” on page 4-145.
10. Remove the inner cover. See “Inner cover removal” on page 4-4.
11. Remove the inner plate. See “Inner plate removal” on page 4-98.
12. Remove the ATC sensor PCB bracket. See “ATC sensor PCB bracket removal” on page 4-29.
13. Remove the waste toner auger chute. See “Waste toner auger chute removal” on page 4-194.
14. Lift the appropriate plastic gate, and push it in to reduce toner spillage.
15. Detach the lower portion (A) of the auger from the appropriate developer housing.
16. Swing the lower portion of the auger to the right to enable access to the two screws.
1
2
A