4-192 Service Manual
7558-xxx
4. Release the two clamps (C) to release the harness.
5. Swing the PCBA door open.
6. Pull the main power GFI interface out of the machine, and swing it out of the way. See the “Main power
GFI interface removal” on page 4-119.
Note: The cables do not have to be removed from the main power GFI interface to remove this part.
7. Remove the PC/developer drive motor. See the “PC/developer drive motor removal” on page 4-138.
8. Disconnect the cable (D) from the waste toner agitator motor.
9. Release the harness from the clamp (E).
10. Remove the two screws (F) securing the motor cover to the machine.
11. Remove the motor cover.
To Next Page
Loading...
