Lexmark X95 series - Page 889

Repair information 4-411
7558-xxx
Go Back
Previous
Next
6. Remove the five screws securing the stapler unit frame (A) to the plate (B).
7. Remove the stapler unit frame (A).
8. Release the harness from the three clamps on the stapler unit frame (A).
9. Remove the two screws securing the stapler carriage motor assembly (C) to the stapler carriage
assembly (D).
10. Remove the stapler carriage motor assembly (C).
11. Remove the screw securing the stapler cover (E) to the stapler unit assembly (F).
12. Remove the stapler cover (E).
13. Disconnect the two connectors from the stapler unit assembly (F).
14. Disconnect the connector from the sensor (stapler carriage HP) (G).
15. Remove the two screws securing the bracket (H) to the stapler carriage assembly (D).
16. Remove the bracket (H).
A
B
C
Clamp