215916 476 Revision A
Figure 5.238: Right Caster Wheel Extension
6. Slide the left and right extensions equal distances in either
the inboard or outboard directions, and align its holes at
the desired locations.
NOTE:
To assist moving the extensions, rotate the caster so the
wheel is parallel to the walking beam.
Figure 5.239: Adjustable Caster Wheels
IMPORTANT:
Ensure the caster wheels are positioned at equal distances
from the center of the windrower.
Figure 5.240: Caster Wheel Extensions
7. Position bracket (A) and install back bolts (C).
8. Install bottom bolts (B).
9. Tighten bolts as follows:
a. Snug bottom bolts (B), then snug back bolts (C).
b. Tighten and torque back bolts (C) to 746–770 Nm
(550–570 lbf·ft).
c. Tighten and torque bottom bolts (B) to 746–770 Nm
(550–570 lbf·ft).
10. Repeat Step 7, page 476 to Step 9, page 476 on the
opposite side.
11. Lower the windrower to the ground.
IMPORTANT:
Torque bolts after first 5 and 10 hours of operation.
MAINTENANCE AND SERVICING
To Next Page
Loading...
