Oracle FS1-2 - Page 13

Figure 55: CMA slide rail connector inserted into the back of the right slide rail.......................85
Figure 56: CMA slide rail connector inserted into the back of the left slide rail.........................86
Figure 57: Pilot with mounting brackets inserted into the slide rails..........................................87
Figure 58: Pilot inserted into the rack........................................................................................88
Figure 59: Oracle FS System
Controller....................................................................................90
Figure 60: Controller air filter.....................................................................................................90
Figure 61: Air filter release tabs.................................................................................................91
Figure 62: Remove air filter.......................................................................................................92
Figure 63: Insert air filter............................................................................................................92
Figure 64: Fan module .............................................................................................................93
Figure 65: Fan module location.................................................................................................94
Figure 66: Slide the Controller to service position.....................................................................97
Figure 67: Remove power supply cords ...................................................................................98
Figure 68: Captive thumb screws to remove the top cover.......................................................98
Figure 69: Remove fan module ................................................................................................99
Figure 70: Insert fan module ...................................................................................................100
Figure 71: Close Controller top cover......................................................................................101
Figure 72: Power supply location............................................................................................103
Figure 73: Disconnect the power cord ....................................................................................105
Figure 74: Controller power supply latch.................................................................................106
Figure 75: Remove power supply............................................................................................107
Figure 76: Insert power supply ...............................................................................................108
Figure 77: Riser locations .......................................................................................................109
Figure 78: Slide the Controller to service position...................................................................112
Figure 79: Remove power supply cords .................................................................................113
Figure 80: Captive thumb screws to remove the top cover.....................................................114
Figure 81: Captive screws to secure the risers.......................................................................115
Figure 82: Unlock Riser 3 latch ..............................................................................................116
List of Figures
13