Figure 139: Attachment lever and latch on the power cooling module....................................170
Figure 140: Power cooling module orientation........................................................................171
Figure 141: Power cooling module with a fully open attachment lever....................................171
Figure 142: Power cooling module (right side)........................................................................172
Figure 143: Pilot......................................................................................................................174
Figure 144: Identifying X4-2 and X5-2
Pilot front panels.........................................................175
Figure 145: Identifying X4-2 and X5-2 Pilot service labels......................................................176
Figure 146: Pilot battery..........................................................................................................176
Figure 147: Pilot position during component replacement......................................................179
Figure 148: Pilot slide lockout release tabs.............................................................................179
Figure 149: Pilot with fan door open........................................................................................180
Figure 150: Pilot top cover removal.........................................................................................181
Figure 151: Battery removal....................................................................................................182
Figure 152: Battery insertion...................................................................................................182
Figure 153: Pilot top cover installed........................................................................................183
Figure 154: Location of the Pilot release tabs.........................................................................184
Figure 155: SAS HBA..............................................................................................................186
Figure 156: Pilot position during component replacement......................................................188
Figure 157: Pilot slide lockout release tabs.............................................................................189
Figure 158: Pilot with fan door open........................................................................................190
Figure 159: Pilot top cover removal.........................................................................................190
Figure 160: Remove the riser..................................................................................................191
Figure 161: Disconnect SAS cable bundle..............................................................................192
Figure 162: Disconnect the bracket from the SAS HBA..........................................................193
Figure 163: Pilot riser insertion................................................................................................194
Figure 164: Pilot top cover installed........................................................................................196
Figure 165: Location of the Pilot release tabs.........................................................................197
Figure 166: Riser locations......................................................................................................198
List of Figures
16
To Next Page
Loading...
Need help?
General