/
↑−−−−<SET MODE>−−−−−−
・CARRIER DENS.
+7.80000 E+2
・TARGET DENS.
+1.65000 E+3
−−−−−<SUB MENU>−−−−−
MAIN| | |
MENU| | |ENTR
/
↑−−−−<SET MODE>−−−−−−
DENSITY PARAMETER
・COEFFCIENT α
+4.44000 E−4
・THERMAL EXPAN.(β)
+2.40000 E−4
・CARRIER DENS.
+7.80000 E+2
・TARGET DENS.
+1.65000 E+3
−−−−−<SUB MENU>−−−−−
MAIN| | |
MENU| | |ENTR
/
↑−−−−<SET MODE>−−−−−−
DENSITY PARAMETER
・AIR PERIOD
+8.85680 E+3
・WATER DENS.
+9.98100 E+2
・WATER TEMP.
+1.80000 E+1
・WATER PERIOD
+1.32346 E+4
↓−−−−<SUB MENU>−−−−−
MAIN| | |
MENU| | |ENTR
/
−−−−−<SET MODE>−−−−−−
DENSITY PARAMETER
・UNIT
g/l
・CONSTANT
+1.00000 E+0
・REF. TEMP.
+1.50000 E+1
・THERMAL EXPAN.(β)
+2.40000 E−4
↓−−−−<SUB MENU>−−−−−
MAIN| | |
MENU| | |ENTR
E-880TM-3-E
10
⑩ Density calculation - density period with air (AIR PEIOD) p. 108
⑪ Density calculation - density with water (WATER DENS.) p. 108
⑫ Density calculation - water temp. during calibration (WATER TEMP.) p. 109
⑬ Density calculation - dens. period with water (WATER PERIOD) p. 109
To the setup screen pointed by the cursor
SET mode main menu screen ⇒ 6.2 SET mode main menu screen p. 36
⑭ Density calculation - temp. compensate. coeff. for tube spring const.
(COEFFICIENTα.) p. 109
⑮ Density calculation - reference temperature conversion factor of density
(THERMAL EXPAN. (β)) p. 110
⑯ Density calculation - density of carrier fluid (CARRIER DENS.) p. 110
⑰ Density calculation - density of target fluid (TARGEET DENS.) p. 110
To the setup screen pointed by the cursor
SET mode main menu screen ⇒ 6.2 SET mode main menu screen p. 36
① Density calculation - unit setup (UNIT) p. 105
② Density calculation - constants (CONSTNAT) p. 105
⑦ Density calculation - reference temp. setup (REF. TEMP.) p. 107
⑮ Density calculation - reference temperature conversion factor of density
(THERMAL EXPAN. (β)) p. 110
To the setup screen pointed by the cursor
SET mode main menu screen ⇒ 6.2 SET mode main menu screen p. 36
⑯ Density calculation - density of carrier fluid (CARRIER DENS.) p. 110
⑰ Density calculation - density of target fluid (TARGET DENS.) p. 110
To the setup screen pointed by the cursor
SET mode main menu screen ⇒ 6.2 SET mode main menu screen p. 36
②Constants are selected