Oval EL4101 - ⑪ Density Calculation - Temperature During Calibration Tcal (CALIB. TEMP. Tcal); ⑫ Density Calculation - Temperature Coefficient Α(TEMP. COEF. Α)

                     
／                    
−−−−−＜ＳＥＴ ＭＯＤＥ＞−−−−−−

ＤＥＮＳＩＴＹ ＰＡＲＡＭＥＴＥＲ   


ＣＡＬＩＢ． ＴＥＭＰ． ｔｃａｌ  
         ＋２．０００００ Ｅ＋１
                     
                     
                     
＋２．０００００  
       Ｅ＋１
−−−−−−−＜ＩＮＰＵＴ＞−−−−−−−
     ｜ＣＡＮ−｜    ｜     
 ＥＸＩＴ｜ ＣＥＬ｜ＣＬＥＲ｜ＥＮＴＲ 
                     
／                    
−−−−−＜ＳＥＴ ＭＯＤＥ＞−−−−−−

ＤＥＮＳＩＴＹ ＰＡＲＡＭＥＴＥＲ   


ＴＥＭＰ． ＣＯＥＦ． α      
         ＋０．０００００ Ｅ＋０
                     
                     
                     
＋０．０００００  
       Ｅ＋０
−−−−−−−＜ＩＮＰＵＴ＞−−−−−−−
     ｜ＣＡＮ−｜    ｜     
 ＥＸＩＴ｜ ＣＥＬ｜ＣＬＥＲ｜ＥＮＴＲ 
E-880TM-3-E
1
⑪ Density calculation - temperature during calibration t
cal
(CALIB. TEMP. t
cal
)
The temperature during calibration is set up for density calculation.
Density calculation submenu screen p. 123
⑫ Density calculation - temperature coefficient α(TEMP. COEF. α)
The temperature coefficient for temperature calculation is set up here.
Density calculation submenu screen p. 123
←Numerical value input setup
For details of numerical value input setup, see “(1) Numerical value setup screen
(INPUT)” on page 43.
※ For the unit to be set here, the unit set at the temperature input unit setup
(① Temperature input unit setup (UNIT) on page 51) is used. Make sure of
the unit before you set up.
←Numerical value input setup
For details of numerical value input setup, see “(1) Numerical value setup screen
(INPUT)” on page 43.
※ The unit to be set here is “μs/°C”. Make sure of the unit before you set up.