Oval EL4101 - PROM (System Config. Area) Data Check

                     
                     
−−−＜ＩＮＩＴＩＡＬ ＣＨＥＣＫ＞−−−
・ＭＥＭＯＲＹ ＣＨＥＣＫ        
                     
＊＊＊＊＊ ＡＴＴＥＮＴＩＯＮ ＊＊＊＊＊
＊  ＳＹＳＴＥＭ ＳＥＴ ＤＡＴＡ  ＊
＊  ＳＵＭ ＣＨＥＣＫ ＥＲＲＯＲ  ＊
＊ ＳＹＳＴＥＭ ＳＥＴ ＤＡＴＡ   ＊
＊        ＩＳ ＢＲＯＫＥＮ． ＊
＊ ＳＹＳＴＥＭ ＳＥＴ ＤＡＴＡ   ＊
＊            ＣＬＥＡＲ． ＊
＊＊＊＊＊＊＊＊＊＊＊＊＊＊＊＊＊＊＊＊＊

     ｜    ｜    ｜     
     ｜    ｜    ｜ ＯＫ 
E-880TM-3-E
1
Once the model setup program has been cleared,
computation cannot be performed. If this is the case,
reload the model setup program from the model setup
card. Seek our service at the nearest OVAL representative
in your area.
←A screen showing a memory check error
In an E
2
PROM (system config area) data check, whether or not the data stored in
the memory are free from any damage is verified. In this check, Sumcheck data
created at data writing is compared against the sumcheck data created from the
data currently stored in the memory. If an error is found during this check, model
config program will be cleared, bringing up an undefined status in the model
configuration.
After seeing this message, pressing the function key “OK” causes the data to be
cleared.
3.1.10 E
2
PROM (system con fig area) Data Check
CAUTION: