Oval EL4101 - ⑮ Density Calculation - Reference Temperature Conversion Factor of Density (THERMAL EXPAN. (Β))

                     
／                    
−−−−−＜ＳＥＴ ＭＯＤＥ＞−−−−−−

ＤＥＮＳＩＴＹ ＰＡＲＡＭＥＴＥＲ   


ＴＨＥＲＭＡＬ ＥＸＰＡＮ．（β）  
         ＋２．４００００ Ｅ−４
                     
                     
                     
＋２．４００００  
       Ｅ−４
−−−−−−−＜ＩＮＰＵＴ＞−−−−−−−
     ｜ＣＡＮ−｜    ｜     
 ＥＸＩＴ｜ ＣＥＬ｜ＣＬＥＲ｜ＥＮＴ
E-880TM-3-E
11
Quadratic correction submenu screen p. 88
⑮ Density calculation - reference temperature conversion factor of density
(THERMAL EXPAN. (β))
The reference temperature conversion factor of density is set up here for temperature compensation.
←Numerical value input setup
For details of numerical value input setup, see “(1) Numerical value setup screen
(INPUT)” on page 43.
※ The measurement unit to be set here is “g/ml/°C”. Make sure of the unit
before you set up.