Oval EL4101 - ③ Density Parameter - over Alarm Point Setup (over ALARM POINT)

                     
／                    
−−−−−＜ＳＥＴ ＭＯＤＥ＞−−−−−−

ＤＥＮＳＩＴＹ ＰＡＲＡＭＥＴＥＲ   


ＯＶＥＲ ＡＬＡＲＭ ＰＯＩＮＴ   
         ＋１．０００００ Ｅ＋０
                     
                     
                     
＋１．０００００  
       Ｅ＋０
−−−−−−−＜ＩＮＰＵＴ＞−−−−−−−
     ｜ＣＡＮ−｜    ｜     
 ＥＸＩＴ｜ ＣＥＬ｜ＣＬＥＲ｜ＥＮＴＲ 
E-880TM-3-E
131
③ Density parameter - over alarm point setup (OVER ALARM POINT)
The over alarm point of density to be set in the parameter setup mode is set up here.
Density parameter submenu screen p. 130
←Numerical value input setup
For details of numerical value input setup, see “(1) Numerical value setup screen
(INPUT)” on page 43.
※ For the unit to be set here, the unit set at the density parameter unit setup
(① Density parameter unit setup (UNIT) on page 130) is used. Make sure
of the unit before you set up.