Rohde & Schwarz R&S SMW200A - Page 1076

Remote Control Commands
R&S
®
SMW200A
1076User Manual 1175.6632.02 ─ 30
[:SOURce<hw>]:BB:MCCW:EDIT:CARRier:STOP........................................................... 1081
[:SOURce<hw>]:BB:MCCW:EDIT:CARRier:STATe...........................................................1082
[:SOURce<hw>]:BB:MCCW:EDIT:CARRier:EXECute.......................................................1082
[:SOURce<hw>]:BB:MCCW:PRESet
Sets all multi carrier signal parameters to their default values.
Example: See "Programming Examples" on page 1071
Usage: Event
Manual operation: See "Set to Default" on page 401
[:SOURce<hw>]:BB:MCCW:STATe
<State>
Enables/disables the multi carrier CW signal.
Parameters:
<State> 0 | 1 | OFF | ON
*RST: 0
Example: See "Programming Examples" on page 1071
Manual operation: See "State" on page 400
[:SOURce<hw>]:BB:MCCW:CARRier:COUNt <Count>
Sets the number of carriers in the multi carrier CW signal.
Parameters:
<Count> integer
Range: 1 to 160001
*RST: 64
Example: see "Programming Examples" on page 1071
Manual operation: See "Number of Carriers" on page 401
[:SOURce<hw>]:BB:MCCW:CARRier:SPACing <Spacing>
Sets the carrier spacing.
Parameters:
<Spacing> float
Value range depends on the available bandwidth and the num-
ber of carriers, see "Cross-reference between total bandwidth,
carrier spacing, and number of carriers" on page 401.
Range: 0 to depends on the installed options, e.g. 120E6
(R&S SMW-B10)
Increment: 0.01
*RST: 10E3
SOURce Subsystem