Rohde & Schwarz R&S SMW200A - Page 1150

Remote Control Commands
R&S
®
SMW200A
1150User Manual 1175.6632.02 ─ 30
Example:
SOURce:IQ:OUTPut:DIGital:BBMM2:OFLow:STATe?
// 0
// no overflow
Usage: Query only
Options: R&S SMW-B10
Manual operation: See "Signal Monitoring" on page 181
[:SOURce]:IQ:OUTPut:DIGital:BBMM<ch>:OFLow:HOLD:RESet
[:SOURce]:IQ:OUTPut:DIGital:FADer<ch>:OFLow:HOLD:RESet
Resets the overflow hold state and LED.
Example:
SOURce:IQ:OUTPut:DIGital:BBMM2:OFLow:HOLD:RESet
Usage: Event
Options: R&S SMW-B10
Manual operation: See "Signal Monitoring" on page 181
[:SOURce]:IQ:OUTPut:DIGital:BBMM<ch>:OFLow:HOLD:STATe?
[:SOURce]:IQ:OUTPut:DIGital:FADer<ch>:OFLow:HOLD:STATe?
Queries an overload since last reset for evaluating the measurement.
Return values:
<State> 0 | 1 | OFF | ON
*RST: 0
Example:
SOURce:IQ:OUTPut:DIGital:BBMM2:OFLow:HOLD:
STATe?
Usage: Query only
Options: R&S SMW-B10
Manual operation: See "Signal Monitoring" on page 181
[:SOURce]:IQ:OUTPut:DIGital:BBMM<ch>:SRATe:COMMon:STATe
<DigIqHsComState>
If enabled, the same sample rate value is applied to all channels.
Parameters:
<DigIqHsComState> 0 | 1 | OFF | ON
Example: See Example "Enabling and configuring the HS DIG I/Q digital
outputs" on page 1144.
Options: R&S SMW-K19
SOURce Subsystem