Rohde & Schwarz R&S SMW200A - Page 1149

Remote Control Commands
R&S
®
SMW200A
1149User Manual 1175.6632.02 ─ 30
USER
increases or decreases the level in increments, determined with
the command [:SOURce]:IQ:OUTPut:DIGital:
FADer<ch>:POWer:STEP[:INCRement].
*RST: DECimal
Example:
:SOURce:IQ:OUTPut:DIGital:BBMM2:POWer:STEP:MODE
USER
:SOURce:IQ:OUTPut:DIGital:BBMM2:POWer:STEP 5 dB
Activates the step width for level variation in 5 dB steps
Manual operation: See "User Variation" on page 180
[:SOURce]:IQ:OUTPut:DIGital:BBMM<ch>:POWer:STEP[:INCRement]
<Increment>
[:SOURce]:IQ:OUTPut:DIGital:FADer<ch>:POWer:STEP[:INCRement] <Increment>
Sets the step width. Use this value to vary the digital I/Q output level step-by-step.
Parameters:
<Increment> float
Range: 0 to 100
Increment: 0.01
*RST: 1
Example: See [:SOURce]:IQ:OUTPut:DIGital:FADer<ch>:POWer:
STEP:MODE on page 1148
Manual operation: See "User Variation" on page 180
[:SOURce]:IQ:OUTPut:DIGital:BBMM<ch>:GDELay:CSTate <CompState>
Enables/disables group delay compensation.
Parameters:
<CompState> 0 | 1 | OFF | ON
*RST: 0
Example:
SOURce:IQ:OUTPut:DIGital:BBMM1:GDELay:CSTate 1
Manual operation: See "Group Delay Compensation" on page 182
[:SOURce]:IQ:OUTPut:DIGital:BBMM<ch>:OFLow:STATe?
[:SOURce]:IQ:OUTPut:DIGital:FADer<ch>:OFLow:STATe?
Queries whether the I/Q output signal is clipped or not.
Return values:
<State> 0 | 1 | OFF | ON
*RST: 0
SOURce Subsystem