Rohde & Schwarz R&S SMW200A - Page 515

Configuring the RF Signal
R&S
®
SMW200A
515User Manual 1175.6632.02 ─ 30
See Chapter 8.7.2.1, "Correlating Parameters in Sweep Mode", on page 501.
"Step Linear"
The step width is a constant value in Hz.
"Step Logarithmic"
The step width is determined logarithmically in %, i.e. as a constant
fraction of the current frequency.
Remote command:
[:SOURce<hw>]:SWEep[:FREQuency]:STEP[:LINear] on page 1213
[:SOURce<hw>]:SWEep[:FREQuency]:STEP:LOGarithmic on page 1213
[:SOURce<hw>]:LFOutput:SWEep[:FREQuency]:STEP[:LINear]
on page 1164
[:SOURce<hw>]:LFOutput:SWEep[:FREQuency]:STEP:LOGarithmic
on page 1164
8.7.5.3 Level Range Settings
Access:
1. Select "RF" > "Sweep/List" > "RF Level Sweep"
2. Select for example "Level Range".
Table 8-10: Range settings dialog: Examples of RF Level and RF Combined Sweep dialogs
> "Level Range" > "Frequency / Level Range"
Settings
Start Level / Stop Level...............................................................................................515
Step Count.................................................................................................................. 516
Spacing....................................................................................................................... 516
Step.............................................................................................................................516
Setting Characteristics................................................................................................ 516
Level Range................................................................................................................517
Start Level / Stop Level
Defines the RF level sweep range by setting the start and end values.
See Chapter 8.7.2.1, "Correlating Parameters in Sweep Mode", on page 501.
Remote command:
RF level sweep:
[:SOURce<hw>]:POWer:STARt on page 1195
[:SOURce<hw>]:POWer:STOP on page 1195
Varying the RF Signal in List or Sweep Mode