Rohde & Schwarz R&S SMW200A - Page 584

Configuring the RF Signal
R&S
®
SMW200A
584User Manual 1175.6632.02 ─ 30
Access:
► Select "RF" > "RF Measurement" > "NRP Sensor Mapping".
The dialog lists all detected R&S NRP sensors for selection and mapping. You can
also browse the network for sensors.
The detected sensors are characterized by the used protocol and the correspond-
ing connector icon. In the "Mapping" column, you can assign the sensor to one of
the available sensor channels. The list can contain several entries but the
R&S SMW can only use up to four sensors simultaneously.
The remote commands required to define these settings are described in Chap-
ter 14.17, "SENSe, READ, INITiate and SLISt Subsystems", on page 888.
Settings
Sensor Mapping List................................................................................................... 584
Scan............................................................................................................................585
Clear............................................................................................................................585
Add Sensor/Hide 'Add Sensor'....................................................................................585
Add Sensor settings....................................................................................................585
└ Add LAN Sensor settings..............................................................................585
└ Add USB Sensor settings............................................................................. 585
Sensor Mapping List
Displays a list of all sensor entries with information on the sensor name, the used pro-
tocol, the connector and the assigned mapping.
If a sensor is connected via LAN or uses the USBTMC protocol, its protocol is indica-
ted as "Visa".
Remote command:
:SLISt[:LIST]? on page 892
:SLISt:ELEMent<ch>:MAPPing on page 894
:SLISt:SENSor:MAP on page 894
Improving Level Performance