Remote Control Commands
R&S
®
SMW200A
948User Manual 1175.6632.02 ─ 30
TM<ch> 1|2|3
Determines the local connector, where:
Option: R&S SMW-B10
SOURce1:INPut:TM1|2|3 = TMC1/2/3 of Baseband A/C and
SOURce2:INPut:TM1|2|3 = TMC4/5/6 of Baseband B/D
Option: R&S SMW-B9
SOURce1:INPut:TM1|2 = TMC1/2 of Baseband A/C and
SOURce2:INPut:TM1|2 = TMC3/4 of Baseband B/D
Parameters:
<Signal> TRIGger | CLOCk | FEEDback | DATA
CLOCk is available only for TM1
DATA is available only for TM2
(default if custom digital modulation with external serial data is
used)
FEEDback is available only for TM3 (R&S SMW-B10)/TM2
(R&S SMW-B9)
Options: TM3, TRIGger|CLOCK requires R&S SMW-B10
Manual operation: See "Signal" on page 729
:OUTPut<hw>:TM<ch>:SIGNal <Signal>
Determines the control signal that is output at the selected connector.
To define the connector direction, use the command :OUTPut<hw>:TM<ch>:
DIRection.
Suffix:
OUTPut<hw>
.
1 | 2
Determines the baseband the connectors belong to, where:
OUTPut1 = Baseband A/C or Baseband 1/3
OUTPut2 = Baseband B/D or Baseband 2/4
TM<ch> 1|2|3
Determines the local connector, where:
Option: R&S SMW-B10
OUTPut1:TM1|2|3 = TMC1/2/3 of Baseband A/C or 1/3 and
OUTPut2:TM1|2|3 = TMC4/5/6 of Baseband B/D or 2/4
Option: R&S SMW-B9
OUTPut1:TM1|2 = TMC1/2 of Baseband A/C and
OUTPut2:TM1 = TMC3 of Baseband B/D
Parameters:
<Signal> MARKA1 | MARKA2 | MARKA3 | SCLA | LATTA | BGATA |
HOPA | CWMODA | TRIGA | MARKB1 | MARKB2 | MARKB3 |
SCLB | LATTB | BGATB | HOPB | CWMODB | TRIGB |
MARKC1 | MARKC2 | MARKC3 | SCLC | LATTC | BGATC |
HOPC | CWMODC | TRIGC | MARKD1 | MARKD2 | MARKD3 |
SCLD | LATTD | BGATD | HOPD | CWMODD | TRIGD
SOURce Subsystem
To Next Page
Loading...