Rohde & Schwarz R&S SMW200A - Page 976

Remote Control Commands
R&S
®
SMW200A
976User Manual 1175.6632.02 ─ 30
// Combine the signals of both paths with fixed ratio
SOURce1:PM1:DEViation:MODe RAT
SOURce1:PM1:RATio 80
SOURce1:PM2:DEViation?
// Response: 1.2
// Query the deviation depth of modulation signal in the first path
SOURce1:PM1:DEViation?
// Response: 1.5
SOURce1:FM1:STATe 1
SOURce1:FM2:STATe 1
The following commands are available:
[:SOURce<hw>]:PM<ch>:STATe......................................................................................976
[:SOURce<hw>]:PM<ch>:SOURce.................................................................................. 976
[:SOURce<hw>]:PM:MODE............................................................................................ 977
[:SOURce<hw>]:PM:DEViation:MODE............................................................................. 977
[:SOURce<hw>]:PM:DEViation:SUM................................................................................978
[:SOURce<hw>]:PM:RATio..............................................................................................978
[:SOURce<hw>]:PM:SENSitivity?.................................................................................... 978
[:SOURce]:PM<ch>[:DEViation].......................................................................................979
[:SOURce<hw>]:PM<ch>:STATe <State>
Activates phase modulation.
Activation of phase modulation deactivates frequency modulation.
Suffix:
PM<ch>
.
1|2
Sets the modulation signal channel.
Parameters:
<State> 0 | 1 | OFF | ON
*RST: 0
Example: See Example "Performing phase modulation" on page 974.
Manual operation: See "State" on page 542
[:SOURce<hw>]:PM<ch>:SOURce <Source>
Selects the modulation source for phase modulation signal.
Suffix:
PM<ch>
.
1|2
Sets the modulation signal channel.
Parameters:
<Source> INTernal | EXTernal | LF1 | LF2 | NOISe | EXT1 | EXT2 | INTB
SOURce Subsystem