Rohde & Schwarz RTM3K-COM2

Remote control commands
R&S
®
RTM3000
552User Manual 1335.9090.02 ─ 09
SPECtrum:MARKer:REFerence:SETup:CMPeak
Centers the display to the highest detected peak.
Usage: Event
SPECtrum:MARKer:REFerence:SETup:CSCReen
Centers the display to the center frequency.
Usage: Event
17.8.4.3 Reference marker
SPECtrum:MARKer:REFerence:SETup:MODE................................................................. 552
SPECtrum:MARKer:REFerence:SETup:INDex..................................................................552
SPECtrum:MARKer:REFerence:SETup:FREQuency......................................................... 552
SPECtrum:MARKer:REFerence:SETup:SPAN.................................................................. 553
SPECtrum:MARKer:RMARker?....................................................................................... 553
SPECtrum:MARKer:RMARker:FREQuency?.....................................................................553
SPECtrum:MARKer:RMARker:LEVel?..............................................................................553
SPECtrum:MARKer:RMODe........................................................................................... 553
SPECtrum:MARKer:REFerence:SETup:MODE
Sets the mode for the selection of the reference peak.
Parameters:
<ReferenceMode> OFF | INDicated | RANGe
The reference marker is set to the peak with a specified index
number.
RANGe
The peak with the highest level within the selected range is set
as the reference marker.
SPECtrum:MARKer:REFerence:SETup:INDex
Sets the reference marker to the peak with the specified index, if SPECtrum:MARKer:
REFerence:SETup:MODE is set to INDicated.
Parameters:
<ReferenceIndex>
SPECtrum:MARKer:REFerence:SETup:FREQuency
Sets the center frequency for the capture range, if SPECtrum:MARKer:REFerence:
SETup:MODE is set to RANGe.
Parameters:
<ReferenceFrequency>
Applications