Jitter analysis and clock data recovery
R&S
®
RTP
1030User Manual 1337.9952.02 ─ 12
Clock frequency ← Explicit clock
Sets the clock freuqnecy of the explicit clock signal. If this value is unknown, you can
use "Estimate clock frequency".
Remote command:
ADVJitter<m>:SIGNal:CLFRequency on page 2264
Estimate clock frequency ← Explicit clock
Calculates an estimate value for the clock frequency.
Remote command:
ADVJitter<m>:SIGNal:CLEStimation on page 2263
Clock multiplier ← Explicit clock
Sets a value for the clock multiplier, the ratio of an internal clock rate to the externally
supplied clock.
Remote command:
ADVJitter<m>:SIGNal:CLFFactor on page 2264
Clock edge ← Explicit clock
The clock edge sets the point in time when the state of the data signal is checked:
"Positive"
Rising edge, a positive voltage change.
"Negative"
Falling edge, a negative voltage change.
"Either"
Both the rising and the falling edge.
Remote command:
ADVJitter<m>:SIGNal:EDGE on page 2263
Advanced jitter and noise (option R&S
RTP- K133/K134)
To Next Page
Loading...
